- Branche: Electrical equipment
- Number of terms: 4774
- Number of blossaries: 0
- Company Profile:
A defect in a winding which causes part of the normal electrical circuit to be bypassed. This frequently results in reducing the resistance or impedance to such an extent as to cause overheating of the winding, and subsequent burnout.
Industry:Electrical equipment
The rotating member of the motor which protrudes past the bearings for attachment to the driven apparatus.
Industry:Electrical equipment
Integral-horsepower shunt motors, are used where the primary load requirements are for minimum speed variation from full-load to no-load and/or constant horsepower over an adjustable speed range at constant potential. Shunt motors are suitable for average starting torque loads.
Typical applications include individual drives for machine tools, such as drills and lathes, and centrifugal fans and blowers which are regulated by means of the discharge opening.
Industry:Electrical equipment
Arrangement of laminations on a rotor or armature to provide a slight angular pattern of their slots with respect to the shaft axis. This pattern helps to eliminate low speed cogging effects in an armature and minimize induced vibration in a rotor as well as reduce associated noise. Also can help to increase starting torque.
Industry:Electrical equipment
A type of bearing with no rolling elements, where the motor shaft rides on a film of oil.
Industry:Electrical equipment
The difference between the speed of the rotating magnetic field (which is always synchronous) and the rotor in a non-synchronous induction motor is known as slip and is expressed as a percentage of a synchronous speed. Slip generally increases with an increase in torque.
Industry:Electrical equipment
Small resistance heater units mounted in a motor, that are energized, during motor shutdown, to prevent condensation of moisture on the motor windings.
Industry:Electrical equipment
Motor with special operating characteristics or special mechanical construction, or both, designed for a particular application and not falling within the definition of a general purpose or definite purpose motor.
Industry:Electrical equipment
An open motor in which the ventilating openings are so constructed that drops of liquid or solid particles falling on it or coming toward it in a straight line at any angle not greater than 100 degrees from the vertical, cannot enter either directly or by striking and running along a surface of the motor.
Industry:Electrical equipment
Motor which employs a main winding and an auxiliary winding, which is called the starting winding. The windings are unlike and thereby "split" the single phase of the power supply by causing a phase displacement between the currents of the two windings thus producing a rotating field. After the motor has attained approximately 75% of rated speed, the starting winding is automatically disconnected by means of a centrifugal switch or by a relay. The motor then continues to run on a single oscillating field, which in conjunction with the rotation of the rotor, results in a rotating field effect. Since there is no rotating field, after the starting winding is de-energized, the rotation cannot be changed until the motor has come to rest or at least slowed down to the speed at which the automatic switch closes. Special starting switches are available as well as special reversing switches which have a means for shunting the open contacts of the automatic switch while the motor is running and thus permits the split phase motor to be reversed while rotating. This type of starting is found typically on single phase fractional motors.
Industry:Electrical equipment
